Meriam M4 Series Precision Calibrator Data Logger Manual Manual de usuario descargar pdf (Pagina 27)

ZM4 Instruction Manual 9R87-B June 2012

Changing Batteries

Loosen the two screws in the battery cover and lift off cover. Remove the

batteries by gently applying pressure to the positive side and pull upward. To

install batteries (Four (4) AA 1.5 volt alkaline batteries) insert the negative

side against the spring and gently apply pressure to lock in the positive side.

The positive (+) and negative (-) battery polarity markings are located in the

bottom of the case for the lower batteries and on the top of case for the

upper batteries, as shown in the illustration. Once the batteries are secured

in the battery compartment, replace battery cover and tighten the two flat

head screws. The battery door is universal and can be installed in either

direction.

Figure 22: Changing Batteries

Warning – To avoid erratic readings replace batteries when

warning message appears.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Sin comentarios

Meriam M4 Series Precision Calibrator Data Logger Manual Manual de usuario Pagina 27